Baileigh TN-250 Hole Saw Tube & Pipe Notcher

Description

Baileigh TN-250 Tube Notcher
TN-250
The TN-250 is one of the most versatile hole saw notchers on the market today. The unique radial vise clamping system allows for clamping tubing from 1/2 inch to 2-1/2 inch OD in any location, including the center of a bend. Hole saws are supported on a massive 1-1/4 inch OD shaft, which also includes a replaceable hex insert for attaching to a standard 1/2 inch drive drill.
Offset copes of up to 1 inch can be accomplished by raising or lowering the cutter assembly. This notcher also allows for the use of 3 inch deep hole saws for making longer cuts in a single pass.
Features
Capacity of 1 to 2-1/2 inch OD
230 degrees of angle adjustment
All CNC machined
Radial vise allows for clamping in the center of a bend
Can offset notch up to 1 inch vertically
1-1/4 inch ground and polished stainless steel shaft
Sealed needle bearing shaft support
Easy mounting: Bolt it to a table or simply clamp it in a vise
Can use 3 inch deep hole saws (
hole saws sold separately
)
Requires an ordinary 1/2 inch hand drill
Visit our website to see our full line of metal fabrication equipment.